PRE-CALIBRATED SENSOR MODULES
ALCOMATE AL6000 PRESTIGE
* Note: These sensors will only fit the new AL6000P Prestige model. It will not fit older models of the AL6000 breathalyzer. The breathalyzer unit must be marked Alcomate "PRESTIGE" Model.

*IMPORTANT: If you purchased your AL6000 Prestige before October 2007, please select the GREEN sensor when replacing. If you purchased your AL6000 Prestige after December 2007, please select the RED sensor when replacing.

If you purchased your AL6000 Prestige between October - December 2007, you must verify whether you have a RED or GREEN sensor module. This can be done by examining the sensor module's circuit board color through the rear air vent on top of the device.
 

Alcomate AL6000P Prestige GREEN Calibration Sensor Module Only*	Boxed	One (1) Unit	$25.00
Alcomate AL6000P Prestige RED Calibration Sensor Module Only*	Boxed	One (1) Unit	$25.00

How do I install a Pre-Calibrated Alcohol Sensor Module?
For the AL6000 Prestige, please take the following steps to install a new sensor module.

Note: This sensor will only fit the new AL6000P Prestige model recently introduced. It will not fit older models of the AL6000 breathalyzer.  The Breathalyzer unit must be marked AL6000 "PRESTIGE"

Prepare your AlcoMate Prestige.	Use a flat, sharp tool to carefully open the top cover.	Lift the breath tube to access the sensor module.
Remove the breath tube. It should remove easily.	Carefully raise the sensor module from the body. Do NOT detach the cable from the body.	Remove the cable from the slot underneath the sensor module.
Prepare a new pre-calibrated sensor module.	Insert the cable into the new sensor. Make sure the blue strip is toward the sensor, as shown.	Replace the sensor module into its original position.
Re-attach the breath tube directly on to the sensor. Make sure the front opening is aligned.	Re-attach the cover on to the top of the body. It should snap in fairly easily.